Planning

DLSPIN2010 - Booster and ID Power Supplies

  • Diamond Light Source Ltd

F01: Prior information notice (prior information only)

Notice identifier: 2023/S 000-027046

Procurement identifier (OCID): ocds-h6vhtk-03fc4c

Published 13 September 2023, 10:33am



Section one: Contracting authority

one.1) Name and addresses

Diamond Light Source Ltd

Harwell Science and Innovation Campus

Didcot

OX11 0ED

Contact

Debbie Pryor

Email

procurement@diamond.ac.uk

Telephone

+44 1235567575

Country

United Kingdom

Region code

UKJ14 - Oxfordshire

Companies House

4375679

Internet address(es)

Main address

https://www.diamond.ac.uk

one.3) Communication

Additional information can be obtained from the above-mentioned address

one.4) Type of the contracting authority

Body governed by public law

one.5) Main activity

Other activity

Scientific Research


Section two: Object

two.1) Scope of the procurement

two.1.1) Title

DLSPIN2010 - Booster and ID Power Supplies

Reference number

DLSPIN2010

two.1.2) Main CPV code

  • 31156000 - Interruptible power supplies

two.1.3) Type of contract

Supplies

two.1.4) Short description

Several cycling power supplies are required for the Booster and an Insertion Device, ID. These are rated at several hundred volts and several hundred amps. The Booster Power Supplies will be required to follow a 5Hz unipolar offset sine wave. The ID power supply will be required to ramp between full positive current to full negative current and back again in about 100mS. DLS will provide the precision current measurement and control loop to regulate the power electronics provide through the contract. The power supplies may be split over more than one contract.

two.1.6) Information about lots

This contract is divided into lots: No

two.2) Description

two.2.2) Additional CPV code(s)

  • 31156000 - Interruptible power supplies

two.2.3) Place of performance

NUTS codes
  • UKJ14 - Oxfordshire

two.2.4) Description of the procurement

Several cycling power supplies are required for the Booster and an Insertion Device, ID. These are rated at several hundred volts and several hundred amps. The Booster Power Supplies will be required to follow a 5Hz unipolar offset sine wave. The ID power supply will be required to ramp between full positive current to full negative current and back again in about 100mS. DLS will provide the precision current measurement and control loop to regulate the power electronics provide through the contract. The power supplies may be split over more than one contract.

two.3) Estimated date of publication of contract notice

31 March 2024


Section four. Procedure

four.1) Description

four.1.8) Information about the Government Procurement Agreement (GPA)

The procurement is covered by the Government Procurement Agreement: Yes